Karcher Pro Hose Extension Coupling for HD and XPERT Pressure Washers (Easy!Lock)

Need more reach from your washer? The Karcher Pro Hose Extension Coupling joins two high pressure hoses to make one longer run. It is made for Karcher HD and XPERT pressure washers fitted with Easy!Lock.

It is a brass double connector with two M22 x 1.5 ends. Brass gives it strength and long-term reliability. A rubber sleeve guards the fitting against knocks and wear on site.

You get more working reach without losing performance. That matters on large commercial sites. It also helps with vehicle cleaning and exterior surface jobs where the machine cannot sit close to the work. Rubber protection takes the knocks when the joint is dragged over rough ground.

Contractors and tradespeople are the target buyers. Check the hoses you plan to join are Easy!Lock hoses and the washer is an HD or XPERT. The Karcher Pro manufacturer warranty applies. Is it only for long runs? Not at all. Any time one hose is too short for the job this coupling fixes it. Add a second hose and the washer can stay in one spot.

A hose extension coupling is a double connector. Each end is an M22 x 1.5 thread, which is the 22mm size with a 1.5mm thread pitch. It sits between two hoses and carries the full water pressure. Brass resists the force and wear. The rubber sleeve stops scuffs and drops from damaging the joint, so the run stays sealed.

Always turn the washer off and release the pressure before joining or splitting hoses. Make sure the coupling is tight so it cannot burst apart. Check the rubber and brass for damage before each use. Keep the joint away from sharp edges and traffic. Wear eye protection and keep people clear of the lance.